After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-Sales Service.
For built-in dimensions and installation instruction, see the pictures in page 2.
PREPARING THE CABINET FOR FITTING
WARNING
•
The distance between the underside of the appliance and the separator panel must respect the dimensions given in the figure.
•
In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. 5 mm).
•
If an undertop oven is installed, make sure the oven is equipped with a cooling system.
•
Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could damage them.
•
In the case of flush-mounted installation, call the After-Sales Service to request assembly of screws kit 4801 211 00112.
•
To remove the hob, use a screwdriver (not provided) to prise off the perimeter clips on the underside of the appliance.