Advertisement

DIRECTIONS FOR USE
Induction ceramic hob

Advertisement

Table of Contents
loading

Summary of Contents for Smeg SIHP3+WG4

  • Page 1 DIRECTIONS FOR USE Induction ceramic hob...
  • Page 2 Dear clients, Thank you for having chosen our induction ceramic hob. In order to make the best use of your appliance, we would advise you to read carefully the following notes and to keep them for a later consulting.
  • Page 3: Table Of Contents

    Summary Safety Precautions before using Using the appliance Cleaning Precautions not to damage the appliance Precautions in case of appliance failure Other protections Description of the appliance Technical data Control panel Sensitive touches Display Residual heat indicator Ventilation Starting-up and appliance management Before the first use Induction principle Starting-up...
  • Page 4: Safety

    SAFETY Precautions before using  Unpack all the materials.  The installation and connecting of the appliance have to be done by approved specialists. The manufacturer can not be responsible for damage caused by building-in or connecting errors.  To be used, the appliance must be well-equipped and installed in a kitchen unit and an adapted and approved work surface.
  • Page 5: Precautions In Case Of Appliance Failure

     Sugar , synthetic materials or aluminium sheets must not contact with the heating zones. These may cause breaks or other alterations of the vitroceramic glass by cooling : switch on the appliance and take them immediately out of the hot heating zone (be careful : do not burn yourself).
  • Page 6: Control Panel

    Control panel Timer display [-] key for all 4 heating zones Control light timer [ + ] key Control light cooking zone Power display Booster key Timer key On/Off key Sensitive touches Your ceramic hob is equipped with electronic controls with sensitive touch keys.When your finger touches the key, the corresponding command is activated.
  • Page 7: Residual Heat Indicator

    Residual heat indicator After using a cooking zone an indicator in the form [ H ] will warn you that the surface temperature is high. You should avoid touching this zone. There is a risk of getting burnt. The residual heat can be used to save energy. Ventilation The cooling system is fully automatic.
  • Page 8: Pan Detection

     Start-up/ switch off a heating zone : Action Control panel Display Increase power touch key [ + ] [ 1 ] to [ 9 ] Decrease power touch key [ - ] [ 9 ] to [ 1 ] Stop touch simultaneous [ + ] and [ - ] [ 0 ] or [ H ]...
  • Page 9: Booster Function

    Egg timer function Action Control panel Display Activate the hob Press on key [ 0/I ] The zone control lights are on Select« Timer » Press on key [ Time [ 00 ] minutes [60] wents to 59,58,57,…… Decrease the time Press on key [ - ] Increase the time Press on key [...
  • Page 10: Automatic Cooking

    Automatic cooking All the cooking zones are equipped with an automatic cooking device. The cooking zone starts at full power during a certain time, then reduces automatically its power on the preselected level. Start-up Action Control panel Display Zone selection Press on key [ + ] [ 0 ] and control light on [ 1 ] ……...
  • Page 11: Cooking Advices

    COOKING ADVICES Pan quality Adapted materials: steeel, enamelled steel, cast iron, ferromagnétique stainless-steel, aluminium with ferromagnétique bottom. Not adapted materials: aluminium and stainless-steel without ferromagnétique bottom, cupper, brass, glass, ceramic, porcelain. The manufacturers spécify if their producs are compatible induction. To check if pans are compatibles : ...
  • Page 12: Maintenance And Cleaning

    MAINTENANCE AND CLEANING Do not clean the hob if the glass is hot: risk of burn. Remove light marks with a damp cloth with washing up liquid diluted in a little water. Then rinse with cold water and dry the surface thoroughly. Highly corrosive or abrasive detergents and cleaning equipment likely to cause scratches must be absolutely avoided.
  • Page 13: Environment Protection

    ENVIRONMENT PROTECTION  The packaging materials is ecological and can be recycled.  The worn hob has to be eliminated in conformity with the rules are enforce in your place of residence. Installation instructions The installation comes under the exclusive responsability of specialists. The installer is held to respect the legislation and the standards enforce in his home country.
  • Page 14: Electrical Connection

    How to stick the gasket: The gasket supplied with the hob avoids all infiltration of liquids in the cabinet. His installation has to be done carelessly, in conformity of the following drawing. Stick the gasket (2) two milimeters from the external edge of the glass, after removing the protection sheet (3).
  • Page 15 Caution ! This appliance has only to be connected to a network 230 V~ 50 Hz Connect always the earth wire . Respect the connection diagram. The connection box is located underneath at the back of the hob casing.To open the cover use a medium screwdriver.
  • Page 16 11763/1...

Table of Contents