Table of Contents
Advertisement
26
www.aeg.com
The retaining pins on the
telescopic runners must
point to the front.
11.4 Catalytic cleaning
The cavity is coated with a catalytic
enamel. It absorbs fat.
Before you turn on the Catalytic
cleaning:
• remove all the accessories and
removable shelf supports.
• clean the oven floor with warm water
and mild detergent.
• clean the inner door glass with warm
water and soft cloth.
1. Press
display shows "Cata" and the
duration of the cleaning (1 hour).
You cannot change the duration of the
Catalytic cleaning. You can delay the
start of the cleaning with the function:
END.
The signal sounds at the end of cleaning.
The oven turns off.
2. Press any sensor field to stop the
signal.
3. When the oven cools down, clean
the cavity with a wet soft cloth.
Spots or discolouration of the catalytic
coating have no effect on Catalytic
cleaning.
11.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on
the two door hinges.
again and again until the
A
3. Close the door until it is at an angle
of approximately 45°.
45°
4. Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5. Put the door with the outer side
down on a soft cloth on a stable
surface.
6. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
2
B
CAUTION!
Rough handling of the glass,
especially around the edges
of the front panel, can cause
the glass to break.
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
A
1
Advertisement
Table of Contents
