Air Flow Direction Control - Fujitsu AO G18LBCA Series Service Instruction

1-6. AIR FLOW DIRECTION CONTROL

Individual control
To independently can be set the airflow pattern of each louver as this image.
(Fig.10 : Independent louver control image)
This function is given priority to overall louver control.
But this function is release during the following operation.
Cold air prevention control
Monitor mode on the auto change over operation
Defrost operation
The air direction range will change as follows:
(Fig.11 : Air Direction Range)
Use the wired remote controller to set this function.
This function is only available by 2 wire remote controller.
*When the 2 wire remote controller is disconnected, clear the individual setting.
Otherwise, this setting can't change.
All louver control
All louver operation
Cooling mode standard position: 2
Dry mode standard position: 2
Heating standard position : 4
Monitor mode position: 2
*Setting of the wireless remote controller is not displayed on the wired remote controller.
*The setting louver of the individual control function cannot be controlled.
When the mode is selected, the standard
louver position of the each mode is set.
01-09