Emerson EIM E796 M2CP Installation And Maintenance Manual page 14

Section 4: Limit Switch Setting Instructions
August 2017
2.
Figure 7
NOTE:
Many turns may be required to set limit switches; it may be convenient to use a reversible
variable speed drill to rotate the adjusting shafts instead of a screwdriver.
11
Disengage spring loaded gear: Push Disengage Shaft in (Fig. 7a) down, then rotate
90° so shaft is captured down. This will disengage limit switch gears from spring
loaded drive gear.
Installation and Maintenance Manual
Fig. 7a
Push
Down
Rotate 90°
E2K-402-0817 Rev. 2
Limit Switch Setting Instructions