Table of Contents
Advertisement
Fixing the installation plate
You can select the direction of the drain hose depending on where you want to install the indoor unit. Therefore before fixing
the installation plate to a wall or a window frame, you must determine the position of the 2.56inch(65 mm) hole through which
the cable, pipe and hose pass to connect the indoor unit to the outdoor unit.
When facing the wall, the pipe and cable can be connected from the:
1. Disassemble the cover panel as described in page 40~41.
2. Remove the Hanger plate from the indoor unit.
(1) Unscrew 2 screws that fixes the Hanger plate to the indoor unit.
(2) Push the hooks (on the bottom part of the indoor unit) up to release the installation plate from the hooks that holds it.
(3) Pull the installation plate to release it completely from the indoor unit.
Screw
3. Determine the position of the pipe and drain hose hole as seen in the picture and drill the hole with an inner diameter
of 2.56inch(65mm) so that it slants slightly downwards.
Pipe hole (Ø65 mm)
B
Model
A
09/12
1.42(36) 7.48(190) 3.19(81) 1.42(36)
18/24
1.30(33) 4.33(110) 4.33(110) 1.30(33)
4. Install the indoor unit.
If you install the indoor unit on a wall
(1) Install the installation plate to the wall while giving attention to the weight of the indoor unit.
gaps between the wall and the plate, created by projected anchor, is less than
0.79inch(20mm).
If you install the indoor unit on a window frame
(1) Determine the positions of the wooden uprights to be attached to the window frame.
(2) Attach the wooden uprights to the window frame wall while giving attention to the weight of the indoor unit.
(3) Attach the installation plate to the wooden upright using tapping screws.
If you install the indoor unit on a gypsum board
(1) Use stud finder to find out locations of the studs.
(2) Fix the plate hanger on two studs.
AR7000 CV HP_IB&IM_DB68-05637A-00_EN.indd 39
Direction of pipe
A
D
D
C
Pipe hole (Ø65 mm)
C
B
(Unit : inch(mm))
B
C
D
English-39
B
C
choosing the direction of the pipe.
Plastic
Anchor
Wall
<0.79inch
(20 mm)
2015/10/12 15:43:12
Advertisement
Table of Contents
