Table of Contents
Advertisement
• T he flare nuts are attached to the end of each pipe of an evaporator or a service port.
Use the nuts when connecting the pipes.
• T he wire assembly cable is optional. If it is not supplied, use the standard cable.
• T he drain plug and rubber leg are only included when the air conditioner is supplied without the assembly pipe
as seen in the picture below.
Optional accessories
Insulated Assembly Pipe,
Insulated
Assembly Pipe,
Ø6.35 mm x 4 m (1)
Putty 100 g (1)
Pipe Clamps A (3) Pipe Clamps B (3)
3-wire
Power Cable (1)
• I f these accessories are supplied, they will be in the accessory box or outdoor unit case.
Tools required for installation
General Tools
• Vacuum Pump(Backward flowing prevention)
• Torque Wrench
• Screw Driver
Tools for test operations
• Thermometer
Fixing the installation plate
You can select the direction of the drain hose depending on where you want to install the indoor unit. Therefore before fixing
the installation plate to a wall or a window frame, you must determine the position of the 65 mm hole through which the cable,
pipe and hose pass to connect the indoor unit to the outdoor unit.
When facing the wall, the pipe and cable can be connected from the:
• Right (A)
• Left (B)
• Underside_right (C)
• Rear_right or left (D)
• You can install the refrigerant pipe in the left/right/bottom, or the rear side of the indoor unit.
• If changing the pipe direction from left to right, do not drastically bent it but slowly turn it in the
opposite direction as shown. Otherwise, the pipe may be damaged in the process.
NA_GOOD_A3050_IB&IM_EN_DB68-05202A-02.indd 36
Insulated Assembly Pipe,
Ø9.52 mm x 4 m (1)
Ø12.70 mm x 4 m (1)
✴✴
12
✴✴
✴✴
18
✴✴
2-wire
3-wire
Assembly Cable (1)
Assembly Cable (1)
• Pipe Cutter
• Reamer
• Spanner
• Drill
• Resistance Meter
Direction of pipe
A
D
D
C
Insulated Assembly Pipe,
PE T3 Foam Tube
Ø15.88 mm x 4 m (1)
✴✴
24
✴✴
Cement Nails (6)
Drain Plug (1)
• Manifold Gauge
• Pipe Bender
• L Wrench
• Electroscope
B
English-36
Vinyl Tapes (2)
Insulation (1)
M4 x 25 Tapped
Drain Hose,
Screws (6)
length 2 m (1)
• Stud Finder
• Spirit Level
• Measuring Tape
11/6/2015 2:33:18 PM
Advertisement
Table of Contents
