A) Setting The Clock; B) Set Timer To Std/Auto Mode - Rheem Eco 703 Series Owner's Manual And Installation Instructions

A) Setting the Clock

1. Press and release the (P) button, 'Clock' is displayed flashing on the screen.
2. Press and release the (✓) button to confirm selection. 'Set Clock Day' will be
displayed on the screen with the day selection shown flashing.
3. Press and release the (▲) button until the desired day is selected.
4. Press and release the (✓) button to confirm selection. 'Set Clock HOUR' will
be displayed on the screen with the hours section of the time shown flashing.
5. Press and release the (▲) button until the desired hour (24 hour time)
appears flashing on the screen.
6. Press and release the (✓) button to confirm selection. 'Set Clock MIN' will be
displayed on the screen with the minutes section of the time shown flashing.
7. Press and release the (▲) button until the desired minute appears flashing on
the screen.
8. Press and release the (✓) button to confirm selection. The display will revert
to the main menu and the time setting will be saved.

B) Set Timer to STD/AUTO Mode

1. Press and release the (P) button until 'Timer STD/AUTO' is displayed flashing
on the screen.
2. Press and release the (✓) button to confirm selection. 'STD' will be displayed
flashing on the screen.
3. Pressing and releasing the (▲) button alternates between the 'STD' and
'AUTO' icons.
4. Press and release the (✓) button when the 'STD' or 'AUTO' icon is shown on
the display. The display will revert to the main menu. If 'STD' is selected the
unit will operate 24 hours a day. If 'AUTO' is selected the unit will operate
according to the pre set times on the timer (refer to 'Programming Set ON/
OFF Times' below).
Note: If the timer is in AUTO mode and is in an 'OFF' period, the pressing of any
timer buttons will reactivate the unit. The unit will then operate normally until
the next programmed 'OFF' time.
8