TP-Link NC220 User Manual page 13

Solid Green
 Ethernet Port: The ethernet port is used to connect the camera to a network via RJ45 cable.
 Power Jack: The power jack is where you connect the power adapter to the camera.
 WPS/RESET Button: This button is used for both WPS and RESET function. To use the WPS
function, press it for 1 second. To use the RESET function, press and hold for more than 5
seconds.
Used as the WPS button:

If your wireless router supports WPS (Wi-Fi Protected Setup), you can connect the
camera to your Wi-Fi network using WPS. Press the WPS or QSS button on your router.
Within 2 minutes, press the WPS/RESET button on the camera for 1 second, then the
WPS LED will start flashing quickly. When the LED becomes solid on, the camera is
successfully connected to the router wirelessly..
Used as the RESET button:

With the camera powered on, press and hold the WPS/RESET button for more than 5
seconds until the System LED turns off. Then release the button and wait the camera to
reset to its factory default settings.
 Ventilation Holes: These holes are used for heat dissipation.
NC220
NC230
NC250
The camera has been successfully added to a network by WPS
function. This process will last in the first 2 minutes.
Day/Night Cloud Camera, 300Mbps Wi-Fi
HD Day/Night Wi-Fi Cloud Camera
HD Day/Night Cloud Camera, 300Mbps Wi-Fi
6