Lubrication - Yamaha WaveRunner SuperJet 2020 Owner's/Operator's Manual

(2) Clean the watercraft. (See page 55 for in-
formation on cleaning the watercraft.)
Wax the hull with a non-abrasive wax
such as Yamalube Professional Polish.
EJU40785

Lubrication

Use a Yamaha Power Cable Luber and spray
Yamaha Lube-Zall between the inner and
outer cables to lubricate the cables and
purge out any dirt and moisture.
To keep moving parts sliding or rotating
smoothly, lubricate them with water-resistant
grease.
Recommended water-resistant grease:
YAMALUBE MARINE GREASE
Throttle cable (carburetor end) and choke

cable (carburetor end)
Care and storage
Throttle cable (throttle lever end)

Squeeze the throttle lever and remove the
seal. Spray Yamaha Lube-Zall into the out-
er cable. Refit the seal securely.
1 Seal
Steering cable ball joint (handlebar end)

and steering cable inner wire (handlebar
end)
To access the steering cable ball joint (han-
dlebar end) and steering cable inner wire
(handlebar end), remove the steering pole
cover. (See step 1 in "Adjusting the jet
thrust nozzle angle" on page 61 for infor-
mation on removing the steering pole cov-
er.)
58