Table of Contents
Advertisement
operation
acceptance quality range.
Alarm Output—The board Divert/Alarm has been programmed to operate as
Standard Setpoints on page 20 shows, the relay will energize whenever a
shutdown condition occurs. The relay will remain energized if the shutdown
condition is active. S1 should be left as a powered output for the bypass
feature to function.
Cross Reference Terms on Controller Screen
Tank—Refers to the water collection basin in the tower.
Permeate—The water after having gone through the WaterGard membranes
RO—References WaterGard
Fault Condition Display
High Pressure Fault: Occurs when High Pressure Switch Closes
Line 1—Service Fault
Line 2—High System Pressure
Line 3—
Line 4—To Reset Push OFF/ON
Low Pressure Fault: System is responding to low pressure condition per
system settings
Line 1—Service Fault
Line 2—Low Feed Pressure
Line 3—
Line 4—Restart in MM:S"
Pre Treat Fault: Pretreat Switch is closed indicating problem with the
pretreat system
Line 1—Service Fault
Line 2—Pretreat
Line 3—
Line 4—Check Pretreat Sys
➠
15
Advertisement
Table of Contents
