Advertisement
PROGRAMMING GUIDE
Programming Options
Your Curtis CAFEPC dispenser is factory preset for optimal performance. Generally, there will not be a need to
change the programming. If necessary, the following operating parameters can be changed:
•
Water temperature
•
Manual Dispense Mode/Preset Dispense Mode
•
Product % Ratio
Changing the Water Temperature (Factory Default: 190° F-standard units, 100° F-iced cappuccino units)
The following steps can also be used to read the existing temperature setting. The water temperature range is 80°
to 204°F.
1
The rear toggle switch must be in the ON position and the ready light(s) must be on.
2
Press and hold the STOP/WASH button (for about 10 seconds) until all the lights start blinking, then release.
3
repeated pattern.
4
Read the existing temperature setting according to TABLE 1. After a periodic pause, the number of (quick)
204°F.
# of Flashes
5
To exit without changing the temperature, press one of the PUSH buttons. To change the temperature, press and
hold
desired temperature is indicated according to TABLE 1.
6
Press one of the PUSH buttons to set and exit.
Control panel design varies based on model
Temperature
1
80°F/27°C
2
85°F/29°C
3
90°F/32°C
4
95°F/35°C
5
100°F/38°C
6
105°F/41°C
7
110°F/43°C
8
120°F/49°C
9
140°F/60°C
TABLE 1
STOP/WASH light
# of Flashes
Temperature
10
185°F/85°C
11
190°F/88°C
12
192°F/89°C
13
194°F/90°C
14
196°F/91°C
15
198°F/92°C
16
200°F/93°C
17
202°F/94°C
18
204°F/96°C
PG14
Advertisement
