Vlan - ZyXEL Communications NWA Seres User Manual

Table 37 Configuration > Network > IP Setting (continued)
LABEL
DNS Server IP
Address
IPv6 Address Assignment
Enable Stateless
Address Auto-
configuration
(SLAAC)
Link-Local
Address
IPv6 Address/
Prefix Length
Gateway
Metric
DHCPv6 Client
DUID
Request Address
DHCPv6 Request
Options
DNS Server
NTP Server
Apply
Reset

9.3 VLAN

This section discusses how to configure the Zyxel Device's VLAN settings.
Note: Mis-configuring the management VLAN settings in your Zyxel Device can make it
inaccessible. If this happens, you will have to reset the Zyxel Device.
Chapter 9 Network
DESCRIPTION
Enter the IP address of the DNS server.
Select this to enable IPv6 stateless auto-configuration on the Zyxel Device. The Zyxel Device
will generate an IPv6 address itself from a prefix obtained from an IPv6 router in the network.
This displays the IPv6 link-local address and the network prefix that the Zyxel Device
generates itself for the LAN interface.
Enter the IPv6 address and the prefix length for the LAN interface if you want to use a static
IP address. This field is optional.
The prefix length indicates what the left-most part of the IP address is the same for all
computers in the network, that is, the network address.
Enter the IPv6 address of the default outgoing gateway using colon (:) hexadecimal
notation.
Enter the priority of the gateway (if any) on the LAN interface. The Zyxel Device decides
which gateway to use based on this priority. The lower the number, the higher the priority. If
two or more gateways have the same priority, the Zyxel Device uses the one that was
configured first. Enter zero to set the metric to 1024 for IPv6.
Select this option to set the Zyxel Device to act as a DHCPv6 client.
This field displays the DHCP Unique IDentifier (DUID) of the Zyxel Device, which is unique and
used for identification purposes when the Zyxel Device is exchanging DHCPv6 messages
with others. See Appendix B on page 272
Select this option to get an IPv6 address from the DHCPv6 server.
Select this option to determine what additional information to get from the DHCPv6 server.
Select this option to obtain the IP address of the DNS server.
Select this option to obtain the IP address of the NTP server.
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
NWA/WAC/WAX Series User's Guide
98
for more information.