Ac (Ap Controller) Discovery - ZyXEL Communications NWA Seres User Manual

Each field is described in the following table.
Table 39 Configuration > Network > Storm Control
LABEL
Broadcast Storm
Control
Multicast Storm
Control
Apply
Reset

9.5 AC (AP Controller) Discovery

This section discusses how to configure the Zyxel Device's AC Discovery settings. You can have the Zyxel
Device managed by an AC on your network. When you do this, the Zyxel Device can be configured
ONLY by the AC. See
Note: The AC Discovery settings are not available in all Zyxel Devices. See
19 for more information.
If you want to return the Zyxel Device to function in standalone mode, you can do one of the two
following options:
• Press the Reset button.
• Check the AC for the Zyxel Device's IP address and use FTP to upload the default configuration file to
the Zyxel Device. You can get the configuration file at conf/system-default.conf. You must reboot the
Zyxel Device after uploading the configuration file.
To access the Controller Discover screen, click Configuration > Network > AC Discovery.
Figure 57 Configuration > Network > AC Discovery
Chapter 9 Network
DESCRIPTION
Select the check box to enable broadcast storm control on the Zyxel Device. Enabling this
will drop ingress broadcast traffic in the physical Ethernet port if it exceeds the maximum
traffic rate.
Select the check box to enable multicast storm control on the Zyxel Device. Enabling this will
drop ingress multicast traffic in the physical Ethernet port if it exceeds the maximum traffic
rate.
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
Section 9.1.1 on page 94
NWA/WAC/WAX Series User's Guide
102
for more information on AC management.
Section 1.4 on page