Table of Contents
Advertisement
fParallel (LPT) Port Settings [Auto]
Sets parallel port (LPT). If set to Auto, BIOS will optimize the IRQ automatically or
you can set it manually.
fDevice Mode [STD Printer Mode]
Selects an operating mode for parallel port.
[STD Printer Mode]
[SPP]
[EPP-1.9 and SPP Mode]
Power Management Setup
f
Sets system Power Management of EuP2013 and AC Power Loss behaviors. Press
Enter to enter the sub-menu.
fErP Ready [Disabled]
Enables or disables the system power consumption according to ErP regulation.
[Enabled]
Optimize the system power consumption according to ErP
regulation. It will not support S4 & S5 wake up by USB, PCI, PCIe and
PS/2 devices.
[Disabled]
Disables this function.
fRestore after AC Power Loss [Power Off]
Sets the system behaviors while encountering the AC power loss.
[Power Off]
Leaves the system in power off state after restoring AC power.
[Power On]
Boot up the system after restoring AC power.
[Last State]
Restores the system to the previous state (power on/ power off)
before AC power loss.
fSystem Power Fault Protection [Disabled]
Enables or disables the system to boot up when detecting abnormal voltage input.
[Enabled]
Protect the system from unexpected power operating and remain
the shut down status.
[Disabled]
Disables this function.
Windows OS Configuration
f
Sets Windows detailed configuration and behaviors. Press Enter to enter the sub-
menu.
fWindows 10 WHQL Support [Disabled]
Enables the supports for Windows 10 or disables for other operating systems.
Before enabling this item, make sure all installed devices & utilities (hardware &
software) should meet the Windows 10 requirements.
[Enabled]
The system will switch to UEFI mode to meet the Windows
requirement.
[Disabled]
Disables this function.
Printer port mode
Standard Parallel Port mode
Enhanced Parallel Port-1.9 mode + Standard
Parallel Port mode.
45
BIOS Setup
Advertisement
Table of Contents
