Honeywell XYR5000 Quick Start Manual page 2

34-XY-25-11
September 19, 2005
Step 2. Transmitter
To turn the Transmitter on, press the <NEXT> and <ENTER> buttons simultaneously for approximately two seconds, display will flash, then release
the push buttons. The default configuration password is 0000. To accept the password, press <ENTER> four times to accept the four zeroes
The following three parameters must be set to match the corresponding parameters in the Base Radio.
1. Set RF channel (RF CHAN): _________________________ (Please consult your User Manual for details)
2. Set Baud Rate (BAUD RT): __________________________ (Please consult your User Manual for details)
3. Set RF Identification number (RF ID): __________________ (Please consult your User Manual for details)
The RF ID number should be set up sequentially starting at 1. The first Transmitter should be 001, the second Transmitter should be 002, and the
third Transmitter should be 003 and so on.
Step 3. Wireless Management Toolkit (WMT)
WMT is the client/server software that will allow you to monitor, track, and remotely configure the Transmitters. To load the software onto the
computer, load the CD into your computer's CD drive. The software should begin to install automatically. If there are any problems, see page 4 of
the Wireless Management Toolkit User Manual.
To run the software, double click the WMT Icon on your desktop:
User: Admin
Password: password
Please consult the Wireless Management Toolkit User Manual for more information.
Step 4. Output Module
(Including 51453568-001, 51453568-002, 51453568-003)
Wiring Diagram:
Models
51453568-001 and
51453568-003
If using more than one output module, please consult the Electrical Installation section of the Output Module User Manual for "Daisy-Chaining"
instruction.
Power to Output Module: 24VDC
Connection to Base Radio: RS-485 Serial Cable
Analog output connection: 4-20mA Analog Output (must be loop powered!) 51453568-001 and 51453568-003 only
Digital output connection: Digital Switch Output (must be loop powered!) 51453568-002 and 51453568-003 only
Please consult the XYR 5000 Output Module User Manual, Section 5.3, for instructions on mapping the Transmitter input to an output loop on the
module.
Technical Support
For questions during install, please contact Technical Support at:
U.S.: 1-800-423-9883, Europe: +44 1425 463941, email: bill.europe@honeywell.com
Quick Start Guide for XYR5000 Wireless Transmitter
Model
51453568-003
WMT RS-485
From Base Radio
Page 2 of 2
Models
51453568-002 and
51453568-003