Fax Configuration In Elastix; Viewing Sip Trunk Status In Setu Vtep - Matrix Telecom SETU VTEP Configuration Manual

Fax Configuration in Elastix:

 Default FAX protocol in Elastix is Pass-through.
 To configure T.38 in Elastix following command needs to be given from root,
1) Setup /etc/asterisk/udptl.conf manually
2) 2) add "t38pt_udptl=yes" to /etc/asterisk/sip_general_custom.conf
 After allocating above commands Fax with T.38 protocol works if same is set at client
device also.

Viewing SIP Trunk Status in SETU VTEP

Once you have completed configuring the SIP Trunk, you may view its status.
To do this,
 Click the Status link on the left navigation bar.
 Under Status, click the SIP Trunk link.
 The SIP Trunk Status page opens
SETU VTEP configuration guide for Elastix Page | 21