Table of Contents
Advertisement
Tighten down the wingnut
N
clockwise.
Standing in the normal working
N
position, check the depth of cut
again and correct it if necessary.
WARNING
Do not adjust the deflector.
The deflector has been set at the factory
so that the arrow on the deflector and
the open side point away from the
FC 95, FC 110
operator. This ensures that cuttings and
other debris are directed away from the
power tool and operator.
Edging
Start the engine.
N
Start the cut at no less than half
N
throttle and continue cutting at full
throttle.
Hold and guide your power tool so
N
that the blade is vertical.
Cut steadily so that the engine is not
N
lugged down – do not apply force.
Operate at no more than a normal
N
walking pace.
Do not push the blade into the
N
ground.
Always walk forwards when cutting,
N
do not pull the unit towards you.
Cut at a steady pace to avoid having
N
to make several passes.
1
Use the gunning sight (1) to line the
N
blade up with the edge of the bed.
English
13
Advertisement
Table of Contents
