Toro Workman MDX Operator's Manual page 39

Replacing the Carbon Canister
Note:
Replace the carbon canister if it is damaged,
plugged, or if the machine is run without a
carbon-canister filter.
Note:
Replace the carbon-canister filter when
replacing the carbon canister.
Disconnecting the Controls at the Seat Base
1. Remove the knob from the gear-shift lever
(Figure 39).
Figure 39
1. Shifter plate
2. Remove the 4 bolts that secure the shifter plate
to the shifter bracket
3. Remove the 4 bolts that secure the shifter plate
to the seat base and remove the shifter plate
(Figure 39).
Disconnecting the Parking-Brake Cable
1. At the bottom of the machine, remove the cable
tie that secures the parking-brake cable to the
service brake line
2. Mark a rotation stripe on the forward jam nut for
the parking-brake cable
Note:
Ensure that the forward-jam nut does
not rotate.
2. Gear-shift-lever knob
(Figure 39).
(Figure 40).
(Figure 40).
1. Cable tie
2. Parking-brake cable
3. Forward-jam nut
4. Brake-cable bracket
5. Rear-jam nut
3. Loosen the rear-jam nut and remove the cable
from the brake-cable bracket
4. Remove the cotter pin and the clevis pin that
secure the clevis for the parking-brake cable to
the brake-actuating lever and separate the cable
from the lever
5. Repeat steps
cable at the other side of the machine.
Removing the Seats and Seat Bases
1. At the bottom of the machine, remove the 8
flange-head bolts and 8 washers that secure the
g026304
seat base to the floor plate and rear-cab channel
(Figure 41).
1. Flange-head bolt
2. Washer
3. Hole (rear-cab channel)
39
Figure 40
6. Front of the machine
7. Clevis
8. Cotter pin
9. Clevis pin
10. Brake-actuating lever
(Figure
(Figure 40).
1 through 4 to the parking-brake
Figure 41
4. Hole (floor plate)
5. Front of the machine
g029670
40).
g029658