Toro Workman MDX Operator's Manual page 31

Figure 23
1. Flange-head bolts (3/8 x
3/4 inch)
2. Spindle
4. Remove the dust cap from the hub
Figure 24
1. Cotter pin
2. Spindle
3. Tab washer
5. Remove the cotter pin and nut retainer from the
spindle and spindle nut
6. Remove the spindle nut from the spindle, and
separate the hub and rotor assembly from the
spindle (Figure 24
3. Caliper bracket (brake
assembly)
(Figure
4. Spindle nut
5. Nut retainer
6. Dust cap
(Figure 24).
and Figure 25).
1. Spindle
g033047
7. Wipe clean the spindle with a rag.
8. Repeat steps
the other side of the machine.
24).
g033048
31
Figure 25
2. Hub and rotor assembly
1 through 7 to the hub and rotor at
g033049