Toro Workman MDX Operator's Manual page 34

1. Air-filter housing
2. Air-filter element
3. Release the latches securing the air-filter cover
to the air-filter housing
4. Separate the air-filter cover from the air-filter
housing, and clean the inside of the cover
(Figure 30).
5. Gently slide the air-filter element out of the filter
housing.
Note:
To reduce the amount of dust dislodged,
avoid knocking the filter against the air-filter
housing.
6. Inspect the air-filter element.
•
If the air-filter element is clean, install the
filter element; refer to
(page 34).
•
If the air-filter element is damaged, replace
the filter element; refer to
Filter (page 34).
Replacing the Air Filter
1. Remove the air-filter element.
2. Inspect the new filter for shipping damage.
Note:
Check the sealing end of the filter.
Important:
Do not install a damaged filter.
3. Install the new air filter; refer to
Filter (page 34).
Installing the Air Filter
Important:
To prevent engine damage, always
operate the engine with the complete air cleaner
assembly installed.
Important:
Do not use a damaged element.
Note:
Cleaning of the used air-filter element is not
recommended due to the possibility of damage to the
filter media.
Figure 30
3. Air-filter cover
4. Latch
(Figure 30).
Installing the Air Filter
Replacing the Air
Installing the Air
1. Clean the dirt ejection port located on the
air-filter cover.
2. Remove the rubber outlet valve from the cover,
clean the cavity, and replace the outlet valve.
3. Insert the air-filter element into air-filter housing
(Figure 30).
Note:
Ensure that the filter is sealed properly
by applying pressure to the outer rim of the filter
when installing it. Do not press on the flexible
center of the filter.
4. Align the air-filter cover with the air-filter housing
g027733
(Figure 30).
5. Secure the cover to the housing with the latches
(Figure 30).
6. Lower the cargo bed.
34