I/O Board; Removing The I/O Board - Dell P117F001 Service Manual

5. Close the right display hinge and align the screw holes on the right display hinge with the screw holes on the system board.
6. Replace the three screws (M2.5x5) that secure the right display hinge to the palm-rest and keyboard assembly.
7. Replace the display cable to the routing guides on the palm-rest and keyboard assembly.
8. Connect the display cable to the connector on the system board.
9. Close the latch and replace the clear adhesive tape.
Next steps
1. Install the base cover.
2. Follow the procedure in

I/O board

Removing the I/O board

Prerequisites
1. Follow the procedure in
NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the base cover.
About this task
NOTE:
A RJ-45 Network Port assembly for the I/O board is required.
If you are replacing the I/O board, transfer the existing RJ-45 Network Port assembly to the replacement I/O board.
The following image(s) indicate the location of the I/O board and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Before working inside your
Removing and installing components 39