NOTE:
This is the heatsink for your computer that supports the integrated Graphics Processing Unit (GPU).
Steps
1. Align the screw holes on the heat sink to the screw holes on the system board.
2. In sequential order (1>2>3>4>5>6>7) or (1>2>3>4), tighten the seven or four captive screws, whichever is applicable, that
secure the heat sink to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
base
cover.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the removal
procedure.
36
Removing and installing components
After working inside your
Before working inside your
computer.
computer.
Before working inside your