Table of Contents
Advertisement
12. Replace the two screws (M2x4) that secure the Type-C port-bracket to the system board.
13. Connect the power-adapter port cable to the system board and replace the adhesive tape on the cable.
14. Connect the display cable to the system board, close the latch of the display cable connector and replace the clear adhesive
tape on the display cable connector.
15. Close the right display hinge and align the screw holes on the right display hinge with the screw holes on the system board.
16. Replace the three screws (M2.5x5) that secure the right display hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the heatsink.
2. Install the
wireless
card.
3. Install the
M.2 2230 solid-state drive
4. Install the
memory
module.
5. Install the
base
cover.
6. Follow the procedure in
Power button with optional fingerprint reader
Removing the power button with optional fingerprint reader
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
base
cover.
About this task
The following image(s) indicate the location of the power button and provides a visual representation of the removal procedure.
or
M.2 2280 solid-state
After working inside your
Before working inside your
drive, whichever is applicable.
computer.
computer.
Before working inside your
Removing and installing components
51
Advertisement
Table of Contents
