Table of Contents
Advertisement
8. Secure the power supply cord and connecting cable onto
the control board with the holder.
9. Close grille door by tighten with screw and close the front
panel.
This equipment must be properly earthed.
• Ensure the colour of wires of outdoor unit and the
terminal Nos. are the same to the indoor's respectively.
• Earth lead wire shall be Yellow/Green (Y/G) in colour and
longer than the other AC wires as shown in the figure for
the electrical safety in case of the slipping out of the cord
from the anchorage.
• Note: Isolating Devices (Disconnecting means) should
have minimum 3.0 mm contact gap.
11.2.5. Wire Stripping And Connecting Requirement
11.3. Outdoor Unit
11.3.1. Install The Outdoor Unit
• After selecting the best location, start installation according to Indoor/Outdoor Unit Installation Diagram.
1. Fix the unit on concrete or rigid frame firmly and
horizontally by bolt nut (ø10 mm).
2. When installing at roof, please consider strong wind and earthquake. Please fasten the installation stand firmly with bolt or
nails.
Model
C12***, PC12***,
C18***, PC18***
C24***, PC24***
612.5 mm
21
A
B
C
570 mm
105 mm
18.5 mm
131 mm
19 mm
D
320 mm
383 mm
Advertisement
Table of Contents
