5-In-1 Sensor Installation - AcuRite 01506 Instruction Manual

5-in-1 Sensor Installation Guidelines
INSTALLATION HEIGHT
(1.5 meters) off the ground, in an open area. Higher is better for wind
measurements - The National Weather Service recommends 33 feet high!
MOUNTING OPTIONS
directly onto wooden posts or surfaces that are 2x4 or larger. The sensor can
also be mounted directly to common 3/4" steel pipe (available at hardware
stores and home centers).
LEVEL INSTALLATION
level (included on top of sensor) to
ensure level installation for accurate wind
measurement.
SOLAR CELL INSTALLATION
sensor with the solar cell facing SOUTH.
This ensures the cell receives as much sun
as possible and orients wind direction.

5-in-1 Sensor Installation

1. Fasten mounting base (included) to a
post or pole (not included) using the
4 longer screws included in the
hardware bag.
2. Insert the mounting base into the hole
on the bottom of the sensor.
3. Make sure the arrows on the top of
the sensor are pointed in the proper
direction and the bubble level is
centered. The solar cell should be
facing south to properly orient the wind direction.
4. Fasten the sensor into the mounting base using the 2 shorter screws included
in the hardware bag.
Clear Data Collected During Installation
When installation is complete, press and HOLD "CLEAR ALL/RESET" button,
located on the back of the display inside the battery compartment, to clear
erroneous data from the display.
Basic Setup is Complete
The 5-in-1 sensor will now synchronize with the display. It may take a few
minutes for synchronization to complete. If both or one of the units appear to
be functioning improperly, please refer to the troubleshooting section.
Mount the sensor at a minimum height of 5 feet
The included mounting bracket it designed to screw
Use the bubble
Install the
The 5-in-1 sensor is now ready to use.
NO OBSTRUCTIONS
ABOVE OR AROUND
T H
S O U
11
(1.5 meters)