Bosch SHP65CM5N Use And Care Manual page 28

en-us Troubleshooting
Issue
Four vertical LED's (i.e. the cycle
duration indicators and the clean
indicator) all light up at the same
time.
Four vertical LED's (i.e. the cycle
duration indicators and the clean
indicator) are all flashing.
Dishware is not dry.
28
Cause and troubleshooting
Filters in the water connection of the supply or AquaStop hose are blocked.
Switch off the appliance.
1.
Pull out the power cord plug.
2.
Turn off the water faucet.
3.
Unscrew the water connection.
4.
Remove the filter from the supply hose.
5.
Clean the filter.
6.
Reinsert the filter in the supply hose.
7.
Screw the water connection back on.
8.
Check the water connection for leaks.
9.
Restore the power supply.
10.
Switch the appliance on.
11.
Inlet hose is kinked.
Install the inlet hose without kinks.
▶
Water faucet is turned off.
Turn on the faucet.
▶
There is a technical issue.
Press .
1.
Pull out the power cord plug of the appliance or switch off the breaker.
2.
Wait at least 2 minutes.
3.
Insert the power cord plug of the appliance in a power outlet or switch on the
4.
breaker.
Switch the appliance on.
5.
If the problem occurs again:
6.
Press ⁠ .
‒
Turn off the water faucet.
‒
Pull out the power cord plug.
‒
Contact customer service → Page 35 and give the error code.
‒
No rinse aid used or dosage set too low.
Add Rinse aid → Page 14 .
1.
Set the amount of rinse aid to be dispensed.
2.
→ "Setting the amount of rinse aid", Page 15
Cycle or cycle option has no drying phase, or drying phase is too short.
Select a wash cycle with drying. → Page 10
▶
Some option buttons decrease the drying result.