Table of Contents
Advertisement
rprbk202 Page 12 Tuesday, February 16, 1999 8:28 AM
5-12 Card and hookswitch parts
Installing a card reader datajack bezel
Assembling an upgrade kit
NTP: 506-6501-202 Issue: 00.01 Status: Standard Date: June 1998
This bezel attaches in the same manner as a card reader
bezel.
See this:
Datajack upgrade
If you are installing the datajack
bezel as an upgrade, you may
need to replace the control PCP or
Upload
the firmware.
CDRs and
If this is the case, it is important
uninstall
that you upload the CDRs and
uninstall the terminal before you
start your maintenance.
You will then need to run the
INSTALL routine when you are
finished to upload the proper data-
jack parameters.
The datajack bezel consists of two pieces:
•
the bezel itself, which has a square hole in it, above the
card slot
•
the RJ11 teladapt connector with a two-wire cable,
which is the datajack plug-in.
Advertisement
Table of Contents
