Inserting The Coin Shield; Replacing The Datajack Module - Nortel Millennium Desk Manual

4-18 Replacing parts

Inserting the coin shield

Replacing the datajack module

NTP: 506-6501-204 Issue: 00.01 Status: Standard Date: June 1998
A plastic shield the size of a business card fits over the
open back of the card reader to keep coins out of the cir-
cuitry of the terminal.
If you need to add or replace this piece, follow this proce-
dure:
1. Take the back off the terminal.
Refer to Removing the mounting stand on page 4-
8 and Accessing the inside of the set on page 4-14.
2. Fit the coin shield over the open underside on the card
reader.
The tab goes on the right.
3. Reassemble the phone.
The following section describes the procedure for replac-
ing the datajack module. The connector for this module is
located on the handset-side of the set, on the side of the
set.
To replace the module:
1. Upload CDRs.
Refer to Upload CDRs on page 4-2.
2. Remove the mounting stand.
Refer to Removing the mounting stand on page 4-
8, if necessary.
3. Remove the back from the set.
Refer to Accessing the inside of the set on page 4-
14.
4. Locate the datajack board on the main PCP, as shown
in Figure 4-12.