Servicing - Samson 2489/58 Series Mounting And Operating Instructions

Pressure-independent control valves flow regulators with electric actuator and control thermostat
Table of Contents

Advertisement

Servicing

7 Servicing
The regulator does not require much mainte-
nance. Nevertheless, it is subject to natural
wear, particularly at the seat, plug and oper-
ating diaphragm. Depending on the operat-
ing conditions, check the regulator at regular
intervals to avoid possible malfunctions.
DANGER
!
Risk of bursting in pressure equipment.
Valves and pipelines are pressure equip-
ment. Improper opening can lead to device
components bursting.
− Before starting any work on the device, de-
pressurize all plant sections affected as
well as the valve.
− Drain the process medium from all the
plant sections affected as well as the valve.
− If necessary, install a suitable overpressure
protection in the plant section.
− Wear personal protective equipment.
WARNING
!
Risk of personal injury due to residual pro-
cess medium in the valve.
While working on the valve, residual process
medium can escape and, depending on its
properties, may lead to personal injury, e.g.
burns.
− If possible, drain the process medium from
all the plant sections affected and the
valve.
− Wear protective clothing, safety gloves and
eye protection.
32
WARNING
!
Risk of burn injuries due to hot or cold com-
ponents and pipelines.
Depending on the process medium, valve
components and pipelines may get very hot
or cold and cause burn injuries.
− Allow components and pipelines to cool
down or warm up to the ambient tempera-
ture.
− Wear protective clothing and safety gloves.
NOTICE
!
Risk of regulator damage due to incorrect
servicing or repair.
Only allow trained staff to perform service
and repair work.
NOTICE
!
Risk of regulator damage due to exces-
sively high or low tightening torques.
Observe the specified torques when tighten-
ing regulator components. Excessive tighten-
ing torques lead to parts wearing out more
quickly. Parts that are too loose may cause
leakage.
Observe the tightening torques specified in
section 9.2.
Tip
SAMSON's After-sales Service can support
you in drawing up an inspection and test
plan for your plant.
EB 3135-2 EN

Advertisement

Table of Contents
loading

Table of Contents