Advertisement
FIGURE 4
17. Attach the preformed crimped loop on one end of the bottom rope to the hook on the bottom of the slider
bar on the Non-Winch Standard (B). Attach the other end of the bottom rope with the spring hook on the
rope ratchet to the Winch Standard (A). Tension the bottom rope by pulling the rope through the bottom
rope ratchet. See Figure 5.
18. Following the instructions provided loop two small Rope Ratchet Tensioners (E) around each standard and
through the eyelets on the net side tapes. Tension the net sides by pulling the end of the ropes. The net
shall be equally spaced between the standards. Release the Rope Ratchet Tensioners (E) by pressing on the
release button. Rope Ratchet Tensioners (E) should be rotated close to the pole and behind the padding to
19. Once the Net (D) is attached it must be adjusted to its desire height. Loosen the winch to release the net
tension. After the net tension has been released, loosen the locking knobs on the slider bars to allow the
slider bars to freely move up and down. Adjust Net (D) to desired height. Once the top of the Net (D) is at
the desired height, retighten the slider bar locking knobs and re-tension the net. See Figure 6.
20. Once the Net (D) is tensioned at the desired height, install the Height Labels (H). Line up the appropriate
line on the Height Label (F) with the machined height indicator mark on the slider bars. Use a credit card
or something similar to smooth all air bubbles from Height Labels (F).
21. When you are confident that your net set up is correct cut off any excess top and bottom rope leaving
approximately 36" of excess. Singe the ends of both ropes.
22. Install Post Padding (G) and Antennas (H), if applicable.
FIGURE 5
3
Advertisement
