Bison SVB2000A Instruction Manual

————— Instruction Manual —————
M
P A R T S L I S T
Item Qty Description
A 2 Poles
B 2 Slider Bars
See back page for optional volleyball court accessories.
♦
Inspect all contents prior to installation. Report any missing parts to dealer immediately.
♦
Read all instructions before proceeding.
1. Using the volleyball court layout, locate and dig two holes 8" in diameter by 17" deep 36 feet apart*.
Fill hole with wet premix concrete, insert Poles (A), making sure the Slider Bars (B) are square to and
facing each other. See Figure 1 and 2.
*** NOTICE ***
A minimum of 96" of pole must be left above
the playing surface.
2. After the concrete has cured loop the top rope
of the Volleyball Net (C) around the top pulley
and into the rope cleat. Tie each Volleyball Net
(C) tension string to its adjacent eyelet.
See Figure 3.
3. Once the Volleyball Net (C) is attached at both
ends you can adjust the tension by pulling
downward on the top rope in the rope cleats.
All height adjustments will require you to
loosen the top rope, loosen hand knobs, move
the Slider Bars (B) to the new position, then
tighten hand knobs and Volleyball Net (C).
Date: 9/6/12 Rev: 9 B.A.
SVB2000A
ODEL
Recreational Sand Volleyball System
N.J.C. File:\\server\publisher\instructions\svb2000.dwg , svb2000.pub
Item Qty Description
C 1 Volleyball Net
96"
8" Diameter
Playing Surface
17"
1
Figure 1
36'
Slider Bars
Figure 2
Ref#: 960060