Bison ST125F Instruction Manual

—— Instruction Manual ——
ST125F CONVERTIBLE
S
PORT
Always check that your wheels roll freely and that they are clean before rolling the scoring table onto your
1. Roll the scoring table to the desired location. From the center, lift the table top up and pull the folding leg
out and slide the locking tube down to lock. While lifting up slightly on each end of the table, swing out
the table legs on both sides making sure that the table braces are secured into the locks on the lower surface
of the table top. Lower the adjustable legs to rest on the floor. Lifting the table brace slightly will allow
the adjustable leg to become fully engaged and stabilize the scoring table. See Figure 2 & 3.
2. When placed in the bleachers, install a platform that fits securely in the bleacher seat, and will safely hold
the weight of the scoring table with a ledge to keep from rolling back. Remove the pins, cotter keys, and
the floor adjustable leg and install the bleacher adjustable leg, and reinstall the pins and cotter keys. Hang
adjustable legs not in use on hooks provided on the back side of padding. See Figures 1 and 4.
The power strip is located on the backside of the front padding towards the top.
3. When storing the score table, raise the adjustable legs up to the storage position, lift the ends of the table
top slightly, fold the legs in, raise the locking tube up on the center folding leg and push in the folding leg
to place the table top in the folded position.
4. The Scoring Table Graphic Padding is digitally printed and has been liquid laminated to produce enhanced
image quality, prevent UV fading, and provide protection from minor scratches. Due to the nature of this
product in its intended application; you will experience normal wear and tear from contact. You may
attempt to remove light scuffmarks or stains with warm water and mild dish soap or windex wiping gently
being certain to rinse thoroughly. (Note: The use of any chemical other than mild dish soap or windex,
may remove protective laminate as well as printed color.)
Date: 7/30/09 Rev:
FLOOR MODEL
P G S
RIDE RAPHIC CORERS
floor. Failure to do so may scratch the floors finish.
(Note: The power strip does not provide surge protection)
Figure 1
I.R. B.A. N.J.C.
T
ABLES
WARNING!!!
NOTICE!!!
File: \\N:\INSTRUCTIONS\ST125INST
1
Customer Service
(800) 247-7668
Figure 2
Ref#:880032