Dometic CF16 Operating Manual page 11

CoolFreeze
6.4 Connecting the cooling device
The cooler can be operated with 12 Vg or 24 Vg or 100 – 240 Vw.
A
NOTICE! Danger of Damage!
• Disconnect the cooler and other consumer units from the battery
before you connect the battery to a quick charging device.
• Overvoltage can damage the electronics of the device.
➤ Place the cooler on a firm base.
Make sure that the ventilation slots are not covered and that the heated air can be
dissipated.
Connecting to a battery (vehicle or boat)
A
NOTICE!
For protection of the device the DC cable supplied includes a fuse inside
the plug. Do not remove the fused DC plug. Only use the DC cable sup-
plied.
I
NOTE
If you connect the cooler to the DC socket, remember that the ignition
must be turned on to supply it with power.
➤ Plug the DC connection cable (fig. 6 2, page 3) into the DC voltage inlet of the
cooler (fig. 3 3, page 2).
➤ Connect the connection cable to the DC power outlet.
Connecting to an AC power supply (e.g. at home or in the office)
D
DANGER! Danger of electrocution
• Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
• If you are operating your cooler on board a boat with an AC power
supply, you must install a residual current circuit breaker between the
power supply and the cooler.
Seek advice from a trained technician.
The coolers have an integrated multi-voltage power supply with priority circuit for
connecting to an AC voltage source. The priority circuit automatically switches the
cooler to AC operation, if the device is connected to an AC power supply, even if the
DC connection cable is still attached.
EN
Operation
11