Stamina inmotion 35-1632C Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
STEP 4
Remove the Plastic Caps from the threaded
connectors. Refer to the position of the legs
as shown in illustration 4. First, screw the two
LEGS(7) with Warning Labels into the threaded
connectors on the rail frame. Next, attach the
remaining four LEGS(7).
STEP 5
Place the trampoline in the normal use position. Remove
the LEG CAP(8) from the LEG(7) as shown in illustration
5. Loosen the LOCKING KNOB(24) on the SENSOR
DETECTOR(21) to allow the LEG(7) to slide through
the hole in the SENSOR DETECTOR(21). Slide the
SENSOR DETECTOR(21) onto the LEG(7) and slide
up until it touches the rail frame. Adjust the position of
the SENSOR DETECTOR(21) so that the tip is slightly
touching the bottom of the MAT(5). Be sure the SENSOR
DETECTOR(21) is not pressed firmly against the bottom
of the mat or bent downward. If it is not adjusted correctly,
there is a chance that the SENSOR DETECTOR(21) won't
work properly or that the arm will break during use. Lock the
SENSOR DETECTOR(21) in position with the LOCKING
KNOB(24). Press the LEG CAP(8) back on the LEG(7).
STEP 6
Install a AA battery into the METER(20), battery is not
included. See page 13 for detailed battery installation
instructions. Slide the METER(20) onto the MOUNTING
BRACKET(22). Plug the sensor wire on the SENSOR
DETECTOR(21) into the back of the METER(20).
Warning
Label
Remove all of the six
Plastic Caps from the
threaded connectors before
installing the LEGS(7).
9
Attach Meter
on this Leg.
Attach Resistance
Tube on this Leg.
Tip
4.
Warning
Label
Attach Resistance
Tube on this Leg.
5.