Stamina inmotion 35-1632C Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 2
NOTE: Make sure the SECURE PINS(10) are inserted into the ends of RAILS(1, 2) and properly secured
by the Wire Ring. Both ends of the SECURE PINS(10) should have approximately 1/8 inch between
the RAILS(1, 2) and the Wire Ring. Refer to illustration 2.
STOP!
ALWAYS USE TWO OR MORE STRONG PEOPLE TO UNFOLD OR FOLD THE
STAMINA® INMOTION 38" TRAMPOLINE. FAILURE TO USE TWO OR MORE
WARNING STRONG PEOPLE MAY ALLOW THE RAILS TO SPRING BACK INTO THE
!
FOLDED POSITION AND STRIKE SOMEONE WHICH CAN CAUSE SERIOUS
BODILY INJURY OR DEATH.
Keep fingers away from the ends of the rails in the hinge area when unfolding the
Stamina® inMotion 38" Trampoline. Serious injury can occur if fingers are caught
between the ends of the RAILS.
Hold RAILS(3, 4) and push down on RAILS(1, 2) to unfold the Stamina® inMotion 38" Trampoline to
the flat position. The RAILS(1, 4) and RAILS(2, 3) should snap together and be locked by the SECURE
PINS(10) when you reach the flat position. Refer to illustration 2.
2.
STEP 3
Slide the SAFETY PAD(6) over the rail frame. Make sure the holes in SAFETY PAD(6) fit over the threaded
connectors properly. Refer to illustration 3.
HINT : Install one hole over a threaded connector. The next hole installed should be on the connector on
the opposite side of the trampoline.
CAUTION: The SAFETY PAD(6) must be securely attached to the rail frame in the correct position. All six
(6) holes in the SAFETY PAD(6) must fit over a threaded connector on the rail frame as shown
in illustration 4 on the following page. The SAFETY PAD(6) must also cover the elastic bands
on the MAT(5) as shown in illustration 5 on the following page.
Hazard label on trampoline surface reads as follows:
! WARNING!
PREVENT serious INJURY or DEATH.
Rails can SPRING back and STRIKE someone.
ALWAYS fold and unfold carefully with TWO or
more STRONG people.
Do NOT remove this tag.
3.
8
B.
Second Step,
install the Safety
Pad(6) on to
this Threaded
Connector.
A.
First step,
install the Safety Pad(6) on
to this Threaded Connector.