Technical Data - Dexter Laundry 800ETC1-20030.1 Instruction Manual

4. TECHNICAL DATA

Nominal voltage
Nominal frequency
Nominal power
No load speed
Nominal mass of machine
Max. operating mass of machine
Max. mass of workpiece
Max. demensions of workpiece
Diameter of diamond cutting wheel
Bore diameter of diamond cutting wheel
Max. cutting depth at 90º
Max. cutting depth at 45º
Max. cutting length
Kip area mitre cut
Protection class (SK)
Protection type
Note: Recommendation for the operator to wear hearing protection.
The machine is designed for operating in S1 mode (continuous operation) under 800W power and S2
mode (short-term operation) under 900W power. S2 mode means that you can operate the machine for
an uninterrupted period of 10 minutes at most with a nominal load after this period of time has
elapsed, you must switch off the appliance and allow it to cool down completely. Afterwards, it can be
used again for a maximum of 10 minutes.
Sound and vibration
The noise emission values were measured in accordance with EN 61029 and EN 12418.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Vibration level ah: 2.752 m/s
Vibration level uncertainty K: 1.5 m/s
Note: Recommendation for the operator to wear hearing protection.
Note:
- That the declared vibration total value has been measured in accordance with a standard test method
and may be used for comparing one tool with another;
- That the declared vibration total value may also be used in a preliminary assessment of exposure.
Warning:
- That the vibration emission during actual use of the tool can differ from the declared total value
depending on the ways in which the tool is used.
- Avoid vibration risk.
2
2
230 V~
50 Hz
S1: 800W; S2 : 900W 10min
-1
3000 min
27 kg
50 kg
20 kg
520 X 400 x 10mm
200 mm
25.4 mm
30 mm
25 mm
520 mm
0-45°
I
IP54
72,35 dB(A)
2,5 dB(A)
86,32 dB(A)
2,5 dB(A)
38
RU
KZ
EN