Before Starting The Equipment; Assembly - Dexter Laundry 800ETC1-20030.1 Instruction Manual

Suggestions:
1) Wear gloves while using the tool.
RU
2) Limit the time spent using the tool.
Residual risks
KZ
Even if you use this electric power tool in accordance with the instructions, certain residual risks cannot
be eliminated. The following hazards may arise as a result of the equipment's construction and
layout:
EN
1. Lung damage if no suitable protective dust mask is used.
2. Damage to hearing if no suitable ear protection is used.
3. Damage to health caused by hand-arm vibrations if the equipment is used over long periods of time
or is not properly guided and maintained.

5. BEFORE STARTING THE EQUIPMENT

to the provided base frame, or similar. Before setting up the machine, choose a stable surface, that is
free of obstacles (except materials to be cut) and adequately lit.
• The cutting wheel must rotate smoothly.
• Check that the voltage on the rating plate is the same as your supply voltage before you connect the
equipment to the power supply.
• Always stand on the front of the machine (close to the transport handle) when operating.

6. ASSEMBLY

ATTACH THE LEGS TO THE METAL FRAME
• Loosen the hex bolts on the bottom of four legs with 8mm hex key (supplied).
• Align the holes on the top of four legs with the holes on the metal frame of the water container, then
• Tighten the hex bolts with 8mm hex key.
• Place the metal frame with legs assembly on an even, stable and non slip surface and secure the four
legs in place.
FITTING THE WATER CONTAINER
WARNING ! This machine is likely to emit non-ionizing radiation,
medical implants. To reduce the risk of serious or fatal injury, we
recommend persons with medical implants to consult their
physician and the medical implant manufacturer before
operating this machine.
WARNING ! Pull out the power plug before assembling, adjusting
and changing the cutting wheel.
ust be securely screwed to a work bench,
the equipment is switched on.
39