Table of Contents
Advertisement
Issue
Dishware is not dry.
Silverware is not dry.
Appliance interior still wet after
wash cycle.
Food remnants on dishware.
Cause and troubleshooting
Water collects in recesses of dishware or silverware.
Position dishware at an angle where possible.
▶
The combined detergent used has a poor drying performance.
Use rinse aid to improve drying performance.
1.
Use a different combined detergent with a better drying performance.
2.
Extra Dry/intensive drying not activated to improve drying performance.
Activate Extra Dry/intensive drying.
▶
Dishware removed too early or drying process not yet ended.
Wait until the program ends.
1.
Only remove dishware 30 minutes after the program has ended.
2.
Rinse aid used has a limited drying performance.
Use a name-brand rinse aid.
▶
Eco products may have limited effectiveness.
Appliance door does not open automatically at the end of the program
Adjust the appliance door as described in the installation instructions.
▶
The door gap must be at least 2.75" to 4".
Silverware not arranged properly in the silverware basket or silverware drawer.
Droplets can form on the contact points of silverware.
Arrange silverware individually where possible. → Page 17
1.
Avoid points of contact.
2.
Not an error. Condensation drying creates water droplets in the tub. This is normal.
Moisture in the air condenses on the inside walls of the appliance, runs off, and is
pumped out.
No action required.
Dishware was placed too close together or rack is overfilled.
Arrange dishware with sufficient space in between.
1.
The spray jets must reach the surfaces of the dishware.
Avoid points of contact.
2.
Spray arm rotation of the lower spray arm is blocked.
Arrange dishware so it does not obstruct spray arm rotation.
▶
Spray arm nozzles are blocked.
Clean the Spray arms → Page 25 .
▶
Filters are dirty.
Clean the filters.
▶
→ "Cleaning filters", Page 24
Filters are inserted incorrectly and/or not engaged.
Insert the filters properly.
1.
→ "Filter system", Page 24
Twist filters into place.
2.
Selected wash cycle is too light.
Select a more intensive wash program.
▶
Troubleshooting en-us
29
Advertisement
Table of Contents
