Zanussi ZDLN1522 User Manual page 22

Problem and alarm code
The appliance trips the circuit-beaker.
Refer to "Before first use", "Daily use",
or "Hints and tips" for other possible
causes.
Once you have checked the appliance,
deactivate and activate the appliance. If the
problem occurs again, contact an Authorised
Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
12.1 The dishwashing and drying results are not satisfactory
Problem
Poor washing results.
Poor drying results.
There are whitish streaks or bluish lay‐
ers on glasses and dishes.
There are stains and dry water drops
on glasses and dishes.
22 ENGLISH
Possible cause and solution
• The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and the
capacity of the meter or turn off one of the appliances in
use.
• Internal electrical fault of the appliance. Contact an Author‐
ised Service Centre.
We do not recommend using the
appliance until the problem has been
completely fixed. Unplug the appliance
and do not plug it in again until you are
certain that it operates correctly.
Possible cause and solution
• Use more intensive washing programmes.
• Clean spray arm jets and the filter. Refer to "Care and Cleaning".
• Refer to "Daily use", "Hints and tips" and basket loading leaflet.
• Tableware has been left for too long inside the closed appliance.
• There is no rinse aid or the dosage of rinse aid is not sufficient. Fill
the rinse aid dispenser or set the dosage of rinse aid to a higher lev‐
el.
• Plastic items may need to be towel dried.
• For the best drying performance activate the function AirDry.
• Always use the rinse aid, even with multi-tablets.
• The release quantity of rinse aid is too high. Adjust the rinse aid dos‐
age to a lower level.
• The quantity of detergent is too high.
• The released quantity of rinse aid is not sufficient. Adjust the rinse
aid dosage to a higher level.
• The quality of the rinse aid can be the cause.
WARNING!