Downloading The Project To The Control Panel - Philips TSU9800 Starter Manual

4
Configure the Settings for the Control Panel
Set time & date and define the activation method, time outs and screen brightness in the
System Properties of the configuration file on the Settings tabs.
Note On the Control Panel, you can still change a limited set of settings. To access the
Settings on the Control Panel, press and hold the Settings icon
for 3 seconds.
Note During the installation of the editor, several dedicated configuration files for TSU9400 and
TSU9600 were also saved on your PC.
You can open these configuration files, adjust them and download them on the TSU9800
Control Panel.
For more information on customizing these default configuration files, read the Starter's Guides
for the TSU9400 Control Panel and TSU9600 Control Panel.

Downloading the Project to the Control Panel

To download the project to the Control Panel, connect it to your PC with the USB cable enclosed and
click the icon in ProntoEdit Professional.
When you connect the Control Panel to the PC, the Control Panel displays a USB icon in the upper
right corner of the screen.
The PC recognizes the Control Panel as a removable disk
and adds it in the folder list of your Windows Explorer as
'TSU9800'. In the right corner of your Windows taskbar, the
following icon appears.
If the Control Panel is not recognized, try the following
options:
• Unplug the Control Panel and try again a few seconds later.
• Unplug the Control Panel, reset it and try again.
• Check the USB settings on the PC.
Note The Control Panel uses default Windows drivers for recognition. If the problem is not solved
with the options described above, try installing the latest Service Pack for your Windows
version or check the troubleshooting section of your operating system.
Warning Do not pull the USB cable out of the PC during transition of the configuration file.
TSU9800 Starter's Guide
on the touch screen
8