Mounting The Pronto Control Panel; Mounting On A Surface - Philips TSU9800 Starter Manual

TSU9800 Starter's Guide

Mounting the Pronto Control Panel

Use the TSU9800 as:
• A portable Control Panel
Configure it with WiFi and allow the customer to walk around freely with the Control Panel.
• A mounted Control Panel, with fixed connections.
Configure it with an Ethernet connection and make it even more reliable than the wireless
solution.
Choose to mount the Control Panel to the docking station and on a surface. It also allows you
to conceal all connectors and cables.
-or-
Choose to mount it on the wall, making lights and AV settings directly available when
entering the room.

Mounting on a surface

Tip Use a thin, flexible Ethernet cable that can bend easily in the required angle within the docking
station.
1
Unscrew the bottom plate of the docking station and disassemble the docking station.
2
Remove the sticker on the front of the docking station, which covers up the Ethernet
break-out plate.
3
Remove the upper sticker at the back of the Control Panel.
You can now see the Ethernet and Phoenix connectors.
4
Connect the Ethernet and power cables.
With the cables still visible at the back:
1
Cut out the Ethernet break-out plates at the
front (1) and at the back (2) of the docking station, using a knife.
2
Guide the Ethernet cable through the holes in the docking station.
3
Plug the Ethernet cable in at the back of the Control Panel.
4
Plug the power cable in at the back of the docking station.
9
1 2