Learning Commands - Philips TSU6000 User Manual

Learning Commands

You can program the Remote Control commands by
transmitting infrared signals from your existing remote
controls to the Remote Control's learning eye.
To do this, place the Remote Control and the
device's remote control on a flat surface,
100 to 200 mm (4 to 8 inches) apart.
The following buttons can be programmed:
• control panel buttons;
• device actions;
• direct-access buttons and action buttons.
You cannot program the Page Up/Page Down buttons on the Remote Control
directly. You have to program them via ProntoPro Edit.
You cannot program Home panel buttons directly. You have to program them via
the Device menu (see p. 27).
The Remote Control also offers empty control panel buttons which you can
program and label as existing buttons. They are only visible in Learn and Label
mode and appear with label (intended for a specific function) or without label. You
will also see previously deleted buttons: you can restore them by reprogramming
them or you can reuse them for other commands.
User Guide
25
Getting the Maximum out of it
100 to 200 mm
(4 to 8 inches)