Table of Contents
Advertisement
UNPACKING
Caution! This packaging contains sharp objects.
Take care when unpacking. Remove the
machine, together with the accessories
supplied, from the packaging. Check carefully to
ensure that the machine is in good condition
and account for all the accessories listed in this
manual. Also make sure that all the accessories
are complete. If any parts are found to be
missing, the machine and its accessories should
ASSEMBLY
WARNING
ELECTRIC SHOCK can kill.
Keep the electrode holder and
cable insulation in good
condition.
Do not touch electrically live parts or
electrode with skin or wet clothing.
Insulate yourself from work and ground.
Turn the input line switch on the welder
"OFF" before connecting or disconnecting
output cables or other equipment.
Fitting the Torch Parts
The installation of the torches parts should
follow the order according to Fig.2 shown below.
Fig 2
Torch
be returned together in their original packaging
to the retailer.
Do not throw the packaging away, keep it safe
throughout the guarantee period, then recycle if
possible, otherwise dispose of it by the proper
means. Do not let children play with empty
plastic bags due to the risk of suffocation.
Please note: the start cartridge should not be
installed in reverse and the shield cup should be
secured tightly. Do not overtighten the shield
cup as the start cartridge could be broken.
Use the fixing tool to tighten the electrode.
Make sure that the hole in the cutting tip is not
too wide or deformed. An excessively wide or
deformed hole may cause problems for the
cutting arc.
Check whether the holes in the protective ring
are clean. Blocked holes or a damaged ring may
damage the torch due to overheating.
Check the condition of the torch sheath, making
sure it has no parts which are worn or cut or
signs of electrical discharge. Replace worn or
damaged parts immediately.
Amp Drag Tip
Electrode
Start Cartridge
Worn Electrode
21
Shield Cup
Worn Tip
Advertisement
Table of Contents
