Download Print this page
NTI Caprice C95-BF Supplemental Instructions

NTI Caprice C95-BF Supplemental Instructions

Balanced flue

Advertisement

Quick Links

Installation and Maintenance instructions
Supplemental Instructions
For
Caprice (Balanced Flue)
Save these instructions

Advertisement

loading
Need help?

Need help?

Do you have a question about the Caprice C95-BF and is the answer not in the manual?

Questions and answers

Summary of Contents for NTI Caprice C95-BF

  • Page 1 Installation and Maintenance instructions Supplemental Instructions Caprice (Balanced Flue) Save these instructions...
  • Page 2: Installation Components

    1.0 SETTINGS & TECHNICAL DATA RIELLO BURNER Settings Input Nozzle Pump Output Burner Model 60°B (psig) MTUH EFF. Model Turbulator C95-BF 0.75 0.65 89.0% 4-1/4 C105-BF 0.85 0.75 87.8% 5-1/2 0 C125-BF 1.00 0.85 88.2% C150-BF 1.25 1.00 86.0% BECKETT BURNER Input Nozzle Pump...
  • Page 3: Installation Codes

    3.0 INSTALLATION CODES Install the balanced flue system according to CSA S139 codes to ensure a safe operation of your unit. The following guidelines are included in the CSA codes and must be respected at all times: A) Use approved venting components only.
  • Page 4 • Within 1 ft (0.3 m) above grade (ground or any surface that will support snow). • underneath a deck, porch, or veranda • closer than 6 ft (1.8 m) from an inside corner of an L-shaped structure • In a location where the flue gases are directed at any opening of surrounding buildings that are within 6-ft (1.8 m).
  • Page 5 11. The back of the vent terminal is equipped with a flexible heat shield, bend the flaps to the side, and then bend the heat shield up, and out of the way. 12. Silicone caulk the space between the vent terminal and the structure.
  • Page 6 throughout this installation is critical to the operation of the balanced flue system. A tube of caulking is provided with the installation kit. This tube should be sufficient for the whole installation, but if more caulking is needed buy one of the following: GE 106, Dow Corning 736 Heat Resistant Sealant, Perimeter 248 High Temp or RTV Silicone Gasket.
  • Page 7: Important Warning

    7.0 WIRING All wiring must be in accordance with the Canadian Electrical code, CSA C22.2, and any local codes that may become applicable. Insure that the wiring is in accordance with this manual. The boiler must be electrically grounded in accordance with local codes, and C22.2. Important Warning It is the responsibility of the installer to ensure that: •...

This manual is also suitable for:

Caprice c105-bfCaprice c125-bfCaprice c150-bf