Rgb Lights Brightness Setting; Rgb Lights Diy Setting - Harman JBL RALLYBAR S Owner's Manual

Notes:
- Press and hold the and
2 seconds to quickly turn off the RGB lights on front.
- the DIY pattern will be your latest saved Pattern based on your
RGB Light DIY setting

7.3 RGB Lights Brightness Setting

Button Press
RGB Light Brightness Setting Mode
Button Backlights Status
Off
White (Constant)
White (Flashing)
RGB Light Brightness Adjustment Level
Level 1: Minimal
Level 2: 50% Brightness
Level 3: 70% Brightness
Level 4: Max Brightness
1. Press and hold and
to enter or exit from RGB lights brightness menu mode
2. Short press to increase the brightness level; press
decrease from current brightness level
3. press to save the Brightness selection and exit from the
Brightness menu mode
Notes:
- when in RGB lights brightness menu mode, the backlights of the
, and buttons will be white flashing status.
- There are 4 levels brightness selection: Minimal, 50%, 70%, Max
- the brightness level selection is for all RGB lights patterns.
- if there is no action in the brightness menu mode over 2 minutes,
RGB lights brightness menu mode will automatically exit but
brightness adjustment will not be saved.
- Press and buttons simultaneously 2 seconds to exist,
brightness adjustment will not be saved.
- Only press button to confirm, then the brightness adjustment
could be finally saved.
- if press the main power switch to shut down the speaker directly,
the brightness adjustment will not be saved properly for next
time usage, only user press the power button to enter the deep
standby mode first then press the main power switch to shut
down power, then DIY setting will be finally saved.
buttons simultaneously
RGB Light
Behaviors
Power off
In operation mode
1. In RGB Light DIY menu
mode
2. In RGB Brightness menu
mode
buttons simultaneously 2 seconds

7.4 RGB Lights DIY Setting

Button
Button Backlights Status
Off
White (Constant)
White (Flashing)
Off
White (Constant)
Blue (Constant)
1. Rock
2. Flow
3. Cross
4. Ripple
5. Static
6. Mix
to
1. Press and
exit RGB Lights DIY menu.
2. Press or
Flow, Cross, Ripple, Static and Mix.
3. Press button to confirm the pattern selection and enter the
Primary Color Zone menu at the same time
4. Press or
Aquamarine, Blue, Green, Orang, Purple, Red, White, Yellow
and Off.
5. Press button to confirm the Primary color selection and
enter the Secondary Color Zone menu at the same time.
6. Press or
Aquamarine, Blue, Green, Orang, Purple, Red, White, Yellow
and Off.
7. Press button to confirm the secondary color selection and
exit RGB Lights DIY menu.
Notes:
- when in RGB lights DIY menu mode, the backlights of the
and
button will be constant Blue at the same time.
- if there is no action in the RGB lights DIY menu mode over
2 minutes, RGB lights DIY menu mode will automatically exit but
DIY setting will not be saved.
7
RGB Light
Press Behaviors
RGB Light DIY Setting Mode
Power off
In operation mode
3. In RGB Light DIY menu mode
4. In RGB Brightness menu mode
Power off
In operation mode
In RGB Light DIY menu mode
1. Aquamarine
2. Blue
3. Green
4. Orange
5. Purple
6. Red
7. White
8. Yellow
9. Off
buttons simultaneously 2 seconds to enter or
buttons to choose from 6 Light pattern: Rock,
buttons to choose from 9 Light colors:
buttons to choose from 9 Light colors:
buttons will be white flashing status, the backlight of
1. Aquamarine
2. Blue
3. Green
4. Orange
5. Purple
6. Red
7. White
8. Yellow
9. Off
,