Installing The Camera - Ikelite 200DL Manual

Installing the Camera

1. Remove any lanyard or neck strap which may be attached to the
camera.
2. C h e c k t o s e e w h e t h e r t h e c a m e r a ' s l e n s w i l l f i t t h r o u g h t h e p o r t
open ing of the housing. If n ot , th e l en s wi l l n e e d t o b e r e m o v e d
from the camera body and re-attached after the camera body is
installed in the housing.
3. Remove the camera mount plate from the housing.
4. L i n e t h e m o u n t s c r e w u p w i t h t h e c a m e r a ' s t r i p o d s o c k e t . U s e a f l a t
screwdriver to tighten the mount plate to the camera.
1 / 4 - 2 0 t r i p o d
mount
5. P u l l o u t o n t h e h o u s i n g c o n t r o l k n o b s t o m o v e t h e c o n t r o l s o u t o f
the way.
6. I n s e r t t h e m o u n t p l a t e i n t o t h e s l o t o n t h e i n s i d e b o t t o m o f t h e
h o u s i n g . P u s h t h e c a m e r a a l l o f t h e w a y f o r w a r d u n t i l i t s t o p s .
7. Push housing control knobs in and check orientation with the
camera.
The camera may be attached to a tripod using the 1/4-20
»
threaded mounting hole on the bottom of the mount plate.
16
M o u n t s c r e w
Camera
t r i p o d s o c k e t
LENS