Unloading; Unpacking The Mm5C - Siemens MULTIMOBIL 5C Pre-Installation

Hide thumbs Also See for MULTIMOBIL 5C:

1.4 Unloading

The unloading of the unit from the truck can be carried out using any of the following

ways depending on the site conditions:

1) Using a forklift.

2) Using an overhead travelling crane.

3) Using a chain pulley block and tripod.

4) Using conventional ways i.e. using wedges, wooden planks, pipes or rods and

labour etc.

Note: 1. All boxes are provided with transport base.

2. Do not roll the boxes.

3. Do not drop the boxes from a height of more than 20cms.

4. Observe the stickers (This side up) and (handle with care) on the

Packing for proper handling.

Once the unit is removed from the transport, place it on the ground on the base.

The complete system must be inspected for physical damage and / or material

short-fall and factory must be informed accordingly.

The Multimobil 5C consists of fragile components like camera, Image intensifier, X-ray

Tube etc. Sufficient care must be taken while unloading / unpacking the unit. Refer the

unpacking instructions provided on the packing.

Siemens Ltd. Med India

Version 5.0

Pre-installation Instructions

Multimobil 5C

Monitor trolley

for MM5C

Page 8 of 11

Table of Contents