21 Declaration Of Incorporation According To 2006/42/Ec (Machinery Directive) - GEM Tugela R471 Operating Instructions Manual

21 Declaration of Incorporation according to 2006/42/EC (Machinery Directive)

according to the EC Machinery Directive 2006/42/EC, Annex II, 1.B for partly
We,
declare that the following product
Make:
Serial number:
Project number:
Commercial name:
meets the following essential requirements of the Machinery Directive 2006/42/EC:
1.1.3, 1.1.5, 1.1.7, 1.2.1, 1.2.2, 1.2.3, 1.2.4, 1.2.5, 1.2.6, 1.3., 1.3.2, 1.3.3, 1.3.4, 1.3.7, 1.3.8, 1.3.9, 1.5.3, 1.5.5, 1.5.6, 1.5.7, 1.5.8,
1.5.9, 1.5.13, 1.5.14, 1.5.16, 1.6.1, 1.6.3, 1.6.5, 1.7.1.2
We also declare that the specific technical documentation has been compiled in accordance with part B of Annex VII.
Citation of the harmonized standards used in compliance with Article 7 Section 2:
EN ISO 12100:2010-11
EN 593:2017
Citation of other technical standards and specifications used:
EN 558:2017-05
The manufacturer or his authorised representative undertake to transmit, in response to a reasoned request by the national au-
thorities, relevant information on the partly completed machinery. This transmission takes place:
Electronically
Authorised documentation officer
This does not affect the industrial property rights!
Important note! The partly completed machinery may be put into service only if it was determined, where appropriate, that the
machinery into which the partly completed machinery is to be installed meets the provisions of this Directive.
2020-11-10
Joachim Brien
Head of Technical Department
www.gemu-group.com
Declaration of Incorporation
completed machinery
GEMÜ Gebr. Müller Apparatebau GmbH & Co. KG
Fritz-Müller-Straße 6-8
74653 Ingelfingen-Criesbach, Germany
GEMÜ Butterfly valve, metal, pneumatically operated
from 20.03.2019
KL-Metall-pneumatisch-2019
GEMÜ R471
Safety of machinery – General principles for design – Risk assessment and risk re-
duction (ISO 12100:2010)
Industrial valves – Metallic butterfly valves for general purposes
Industrial valves – Face-to-face and centre-to-face dimensions of metal valves for use
in flanged pipe systems
GEMÜ Gebr. Müller Apparatebau GmbH & Co. KG
Fritz-Müller-Straße 6-8
74653 Ingelfingen, Germany
21 Declaration of Incorporation according to 2006/42/EC (Machinery Directive)
31 / 33 GEMÜ R471 Tugela