Table of Contents
Advertisement
add loctite 648
F3-8G-X
3X8X3.5 Thrust Bearing
Important Note:
This part, for tuning reasons,
comes factory pre assembled
with grease and loctite. It is
ready to use.
Important Note:
This part comes pre assembled
WITHOUT thread lock. Follow
the instruction for final assembly.
OXY0081
2.1X5.5X1 Washer
TCEM2x6
M2x6 Hex Cap Screw
page 24
add silicon grease
3.20mm
add loctite 648
OXY0054
3X4X0.1 Shim
2xMR83-ZZ
3X8X2.5 Radial Bearing
OXY0007
Spindle Shaft
OXY0110-Damper Rubber
OXY0079
Damperner Bushing
OXY0137
3.1x5x0.6 Washer
OXY0054
3X4X0.1 Shim
2x5x2
Radial Bearing
OXY0012
3mm
2X3.7X4.4 Bushing
OXY0734-DFC Arm
Important Note:
This part, for tuning reasons,
comes factory pre assembled
with grease and loctite. It is
ready to use.
Chapter 11: Main Rotor Assembly
OXY0666
SST Threaded Rod M2X10
OXY0716
4mm PL linkage Ball M2 thread
35mm
Fine Adjust Shims:
In order to give fine adjustment options,
the extra Hardware Bag contains extra
Shims 3x4x0.1. Start assembly
with one (each side)pre installed shim.
If the Main Grips have
sideway play, add shims as required.
Each Grips must have the same number
of shims. If you add one shim on the left
side, you need to also add one shim on
the right side
Advertisement
Table of Contents
